plot3d<->tecplot convertor, another problem

Creating Tecplot binary data files

Moderators: davetaflin, salter, steve, jprenaud, straton, Chris Idso

jie
Newbie
Posts: 5
Joined: Sun Oct 26, 2008 7:53 pm
Location: Melbourne
Contact:

plot3d<->tecplot convertor, another problem

Postby jie » Sun Nov 30, 2008 4:34 pm

Hello

i tried to use ifort to compile the converter under ubuntu 8.10, but i end up with an error messgae:

----------------------------------------------------------------------------------------
ifort -r8 -O2 -c Tecplot_io.f90
make: *** No rule to make target `xyzq_io.o', needed by `p3d2tec'. Stop.
----------------------------------------------------------------------------------------

then i looked at the makefile, and try to run the command inside the makefile one by one manually, but i just end up with a bunch of ".o" files, such as number.o, p3d2tec.o, scan2.0, scan4.0, but there is no executable p3d2tec file.

does anyone know anything about this?

thank you very much

thadsaab
Newbie
Posts: 5
Joined: Fri Feb 06, 2009 5:34 pm
Location: USA
Contact:

Re: plot3d<->tecplot convertor, another problem

Postby thadsaab » Tue Nov 03, 2009 2:16 pm

There is a mistake in the make file. On line 17, change:

Code: Select all

xyzq_io: xyzq_io.f90 Tecplot_io.f90

to:

Code: Select all

xyzq_io.o: xyzq_io.f90 Tecplot_io.f90


Return to “TecIO Library”

Who is online

Users browsing this forum: No registered users and 2 guests